A+ Chassis Tie-In Upgrade
Take your cage setup to the next level with our A+ Chassis Tie-In option—designed to significantly increase overall strength, rigidity, and safety. Our A+ pillar adds an extra support bar that connects the front of your cage down to the chassis of your vehicle. Instead of the cage only sitting on factory mounting points, this adds a direct tie-in to the frame. In simple terms—it makes your cage a lot stronger. It helps reduce flex, adds support to the front of the vehicle, and improves overall safety.
We offer three levels of A+ to fit your build needs and fabrication experience:
Option 1 – Unwelded Kit
Perfect for experienced fabricators who want full control over final fitment. This kit includes all bars pre-bent and ready for welding and fitting. Tubes are intentionally supplied longer than required, allowing you to achieve tight, precise fitment around plastics and doors. Also included are (2) 1.5” flat disconnects and (2) stubs of 1.5” x .120 wall DOM tubing for chassis tie-in.
Option 2 – Partially Welded Kit (Currently only available for Pro Models)
A great middle-ground option. Your A+ kit is pre-welded based off measurements from our jig to ensure proper geometry and alignment. You’ll receive 1.5” disconnects and 1.5” tubing, allowing you to complete the final tie-in to your chassis yourself.
Option 3 – Fully Welded In-House
Want it done right without the hassle? Bring your vehicle to us and we’ll handle the entire A+ installation from start to finish. Our team ensures precise fitment, clean welds, and maximum structural integrity.
